Skip to main content
Oh dear Another bodge uncovered. Thought I would just drain the oil last night. Main plug came out after a good whack with mallet on bar, way overtightened but intact. Smaller plug on right of pic is under gearbox, started to turn and then continued to turn. Stripped thread, tried pulling and turning but no good. Going to have to drill and tap plug and make a puller to get decent pressure on to unscrew it. Ordered vcoil kit and new plug.

Comments

Post a Comment

Popular posts from this blog

1 comment
Read more

Engine Vibrations

Well after riding Stuarts 640 supermoto and this bike back to back, the vibration had to be coming from somewhere. The rear mount was one thing I hadn't paid too uch attention to when I started the project. Stripped it down at the weekend. I dropped the back of the engine and managed to drift one of the top hat spacers out, but the other one wasn't  having it. Decided to take engine right out to get better access. Was thinking I might have to drill it out. Made a drift from a long stainless bolt and machined the head in the lathe making the lip thinner eventually, with the lip about .5mm thick I got a good contact with the end of the bush and got the bugger out. Both the spacers were about 1mm oversize on the ID so the back of the engine had about 1mm of play.  Next job is to make some new spacers and fit them, have ordered some bar stock for that. May move the oil cooler while its apart.
1 comment
Read more
Been working on cooling system now exhaust is done. Bought TDM850 Rad which has a pressure cap thinking i wouldn't need a separate expansion tank. Now the rad is mounted as high as i can get it, the filler is not the highest point on the system so will need a small expansion tank to fill from. Ordered a RS125 one that should do the job. Fitted some hoses but need some more bends to plumb the red in neatly. Its very congested and tricky round the water pump area.
2 comments
Read more